|
Stamping Tools & Equipment
For postage stamps, separation is the means by which individual stamps are made easily detachable from each other. more...
 Home
Art
Basketry
Bead Art
Candle & Soap Making
Ceramics, Pottery
Crafts Wholesale Lots
Crocheting
Cross Stitch
Decorative, Tole Painting
Drawing
Embroidery
Fabric
Fabric Embellishments
Floral Crafts
Framing & Matting
General Art & Craft Supplies
Glass Art Crafts
Handcrafted Items
Kids Crafts
Knitting
Lacemaking, Tatting
Latch Rug Hooking
Leathercraft
Macramé
Metalworking
Mosaic
Needlepoint
Other Arts & Crafts
Painting
Paper Crafts & Origami
Quilting
Ribbon
Rubber Stamping & Embossing
 Embossing Supplies
Other Stamping & Embossing
Paper, Stationery
Rubber Stamping Idea Books
Rubber Stamping Kits
Rubber Stamps
Stamping Ink & Pads
Stamping Instruction,...
Stamping Tools & Equipment
Scrapbooking
Sewing
Shellcraft
Spinning
Upholstery
Wall Décor, Tatouage
Weaving
Woodworking
Yarn
Methods of separation include:
perforation - cutting rows and columns of small holes;
rouletting - small horizontal and vertical cuts;
diecutting - cut paper to shape using a metal die - used for self-adhesive stamps.;
Early years
In the early years, from 1840 to the 1850s, all stamps were imperforate, and had to be cut from the sheet with scissors or knife. This was time-consuming and error-prone (as mangled stamps of the era attest). Once reliable separation equipment became available, nations switched rapidly. Imperforate stamps have been issued occasionally since then, either because separation equipment was temporarily unavailable (in newborn nations for instance), or to makers of automatic stamp vending equipment (the United States did this in the 1900s and 1910s), as novelties for stamp collectors (particularly when stamps are issued in souvenir sheets), or as errors.
In 1848, Henry Archer patented a "stroke process" for the perforation of stamps, and in 1854 a "rotary process" was patented by William Bemrose and Henry Howe Bemrose. The common aspect of the two processes was the use of rows of small round pins ("combs") to punch out the holes. The processes have been refined since then, but are basically still the ones in use in the 21st century. The key decision for the perforator is the spacing of the holes; if too far apart, the stamps will not separate easily, and the stamps will be likely to tear and be ruined, but if too close, the stamps will tend to come apart in normal handling, causing its own problems.
In a few cases the size of the holes has been a factor. In the case of certain stamps produced by Australia for sale in rolls rather than sheets (coil stamps) a pattern can be seen on the stamp's short side of two small, ten large and two small holes.
The standard for describing perforation is the number of holes (or the "teeth" or perfs of an individual stamp) in a 2-centimeter span. The finest gauge ever used is 18 on stamps of the Malay States in the early 1950s, and the coarsest is 2, seen on the 1891 stamps of Bhopal. Modern stamp perforations tend to range from perf 11 to 13 or so.
Stamps that are perforated on one pair of opposite sides and imperforate on the other have most often been produced in coils instead of sheets, but they can sometimes come from booklet panes. Booklet panes can be associated with any combination of one, two or three imperforate sides. Sheet edges can produce any one imperforate side or two adjacent imperforate sides when the stamp comes from the corner of the sheet.
Read more at Wikipedia.org
|
|
