Other Spinning Items

In aviation, a spin is an aggravated stall resulting in rotation wherein the aircraft follows a downward corkscrew path. more...

Home
Art
Basketry
Bead Art
Candle & Soap Making
Ceramics, Pottery
Crafts Wholesale Lots
Crocheting
Cross Stitch
Decorative, Tole Painting
Drawing
Embroidery
Fabric
Fabric Embellishments
Floral Crafts
Framing & Matting
General Art & Craft Supplies
Glass Art Crafts
Handcrafted Items
Kids Crafts
Knitting
Lacemaking, Tatting
Latch Rug Hooking
Leathercraft
Macramé
Metalworking
Mosaic
Needlepoint
Other Arts & Crafts
Painting
Paper Crafts & Origami
Quilting
Ribbon
Rubber Stamping & Embossing
Scrapbooking
Sewing
Shellcraft
Spinning
Other Spinning Items
Roving, Wool, Fiber
Spinning Wheels & Spindles
Upholstery
Wall Décor, Tatouage
Weaving
Woodworking
Yarn

Spins can be entered unintentionally or intentionally, from any flight attitude and from practically any airspeed--all that is required is sufficient yaw at the moment an aircraft stalls. An incipient spin is typically driven by misapplied inputs made and held by the pilot, whereas a fully developed spin is a self-sustaining maneuver. In either case, however, a specific and often counterintuitive set of actions may be needed to effect recovery. If the aircraft exceeds published limitations regarding spins, or is loaded improperly, or if the pilot uses incorrect technique to recover, the spin can lead to a fatal crash.

In a spin, one wing is sufficiently stalled and generates significant drag but little or no lift, and the other is either not stalled or not stalled as fully as the other, and generates significant lift. This causes the aircraft to autorotate due to the non-symmetric lift and drag. Spins are characterized by high angle of attack, low airspeed, and high rate of descent.

Spins differ from spiral dives which are characterized by low angle of attack and high airspeed. A spiral dive is not a type of stall because the wing is not stalled and the airplane will respond to the pilot's inputs to the flight controls.

How a spin occurs

Certificated, light, single-engine aircraft must meet specific criteria regarding stall and spin behavior. Even so, it is generally true that such an airplane will only depart into a spin if the pilot simultaneously yaws and stalls the airplane (intentionally or unintentionally). Under these circumstances, one wing tends to stall more deeply than the other. The wing that stalls first will drop, increasing its angle of attack and deepening the stall. The other wing will rise, decreasing its angle of attack, and the aircraft will yaw towards the more deeply-stalled wing. The difference in lift between the two wings causes the aircraft to roll, and the difference in drag causes the aircraft to yaw.

One common scenario that can lead to an unintentional spin is an uncoordinated turn towards the runway during the landing sequence. A pilot who is overshooting the turn to final approach may be tempted to apply rudder to increase the rate of turn. The result is twofold: the nose of the airplane drops below the horizon and the bank angle increases. Reacting to these unintended changes, the pilot may then begin to pull the elevator control aft (thus increasing the angle of attack) while applying opposite aileron to decrease bank angle. Taken to its extreme, this can result in an uncoordinated turn with sufficient angle of attack to cause the aircraft to stall. This is called a cross-control stall, and is very dangerous if it happens at low altitude where the pilot has little time to recover. In order to avoid this scenario, pilots are always taught the importance of making coordinated turns.

Read more at Wikipedia.org