Glass Patterns

Architectural glass is glass that is used as a building material. It is most typically used as transparent glazing material in the building envelope, including windows in the external walls. Glass is also used for internal partitions and as an architectural feature. more...

Home
Art
Basketry
Bead Art
Candle & Soap Making
Ceramics, Pottery
Crafts Wholesale Lots
Crocheting
Cross Stitch
Decorative, Tole Painting
Drawing
Embroidery
Fabric
Fabric Embellishments
Floral Crafts
Framing & Matting
General Art & Craft Supplies
Glass Art Crafts
Glass Art Kits
Glass Art Tools
Glass Blowing
Glass Cutters
Glass Grinding
Glass Kilns
Glass Paints
Glass Patterns
Glass Rods
Glass Tiles
Instruction Videos & Books
Other Glass Art Supplies
Soldering
Handcrafted Items
Kids Crafts
Knitting
Lacemaking, Tatting
Latch Rug Hooking
Leathercraft
Macramé
Metalworking
Mosaic
Needlepoint
Other Arts & Crafts
Painting
Paper Crafts & Origami
Quilting
Ribbon
Rubber Stamping & Embossing
Scrapbooking
Sewing
Shellcraft
Spinning
Upholstery
Wall Décor, Tatouage
Weaving
Woodworking
Yarn

When used in buildings, glass is often of a safety type, which include reinforced, toughened and laminated glasses.

Crown glass: The earliest style of glass window

The earliest method of glass window manufacture was the crown glass method. Hot blown glass was cut open opposite the pipe, then rapidly spun on a table before it could cool. Centrifugal force forced the hot globe of glass into a round, flat sheet. The sheet would then be broken off the pipe and trimmed to form a rectangular window to fit into a frame.

At the center of a piece of crown glass, a thick remnant of the original blown bottle neck would remain, hence the name "bullseye." Optical distortions produced by the bullseye could be reduced by grinding the glass. The development of diaper latticed windows was in part due to the fact that three regular diamond-shaped panes could be conveniently cut from a piece of Crown glass, with minimum waste and with minimum distortion.

This method for manufacturing flat glass panels was very expensive and could not be used to make large panes. It was replaced in the 19th century by the cylinder, sheet and rolled plate processes, but it is still used in traditional construction and restoration.

Glass block

Cylinder glass

Sheet glass

Sheet glass (sometimes called window glass or drawn glass) was made by dipping a leader into a vat of molten glass then pulling that leader straight up while a film of glass hardened just out of the vat. This film or ribbon was pulled up continuously held by tractors on both edges while it cooled. After 12 meters or so it was cut off the vertical ribbon and tipped down to be further cut. This glass is clear but has thickness variations due to small temperature changes just out of the vat as it was hardening. These variations cause lines of slight distortions. You may still see this glass in older houses. Float glass replaced this process.

Rolled plate glass

The glass is taken from the furnace in large iron ladles, which are carried upon slings running on overhead rails; from the ladle the glass is thrown upon the cast-iron bed of a rolling-table; and is rolled into sheet by an iron roller, the process being similar to that employed in making plate-glass, but on a smaller scale. The sheet thus rolled is roughly trimmed while hot and soft, so as to remove those portions of glass which have been spoiled by immediate contact with the ladle, and the sheet, still soft, is pushed into the open mouth of an annealing tunnel or temperature-controlled oven called a lehr, down which it is carried by a system of rollers.

Read more at Wikipedia.org